Hook and Antler Decal
This hook and antler decal is a perfect gift for any occasion.
Stick it on your boat, tumbler, your laptop/tablet, cell phone, car window, journal and more!
The vinyl decal shown in the photos is 6″ x 6″.
We use the highest quality vinyl to make our decals.
The vinyl is permanent adhesive, waterproof and weather resistant with an outdoor durability of 6+ years.
Although, this decal was originally designed to be placed on the exterior glass of an automobile, it can be used for other applications as well.
Apply the decal to boats, laptops, or even add it to one of your own DIY craft projects to give it that special touch.
The possibilities are endless and can be applied to any smooth clean surface; indoors or out.
If you need a custom size contact me.
If you choose to stick this to a wall; this is a permanent adhesive decal. It is NOT removable.
Decals have a top layer referred to as transfer tape and a bottom layer referred to as backing. For best results, apply decals in dry environment with temperature at least 55 degrees Fahrenheit.
STEP 1: Clean the area thoroughly with rubbing alcohol or soap and water. Do not use Windex or similar products because it will leave a residue and prevent the decal from adhering well. Make sure the surface is clean and free of any debris. Wait for the surface to dry before continuing to the next step.
STEP 2: Using a flat surface, prepare the decal for application by firmly rubbing a squeegee or credit card across the top of the decal several times. This removes any air bubbles that may have formed and makes the decal cling to the transfer tape.
STEP 3: Measure from left to right and top to bottom to center for proper alignment. When your decal is where you want it, apply a strip of masking tape along the top edge, this will create a hinge like effect. Then peel the white grid paper backing off the decal. If the decal clings to the paper backing, slowly replace the paper backing and rub across the decal again with a squeegee or credit card. DO NOT allow the decal to touch the surface.
STEP 4: Start at the top, slowly lowering the decal onto the surface and rubbing it in place firmly then rub across the decal with a squeegee or credit card multiple times to ensure it is sticking to the surface.
STEP 5: Slowly peel the transfer tape off at an 45 degree angle holding the tape as flat as possible to the surface. Be careful not to pull the sticker off the surface. If any of the letters pull away from the surface put the tape back down and squeegee the surface again.